JUST STITCHES SLASH STITCH SQUARE DIE SET - Gina Marie DesignsLargest layer approx 4x4 Only the slash marks cut on this die there is not solid line that cuts a shape out. Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need

That means to run them in by a corner first and not flush into the machine

Believe it or not most cutting machines say to cut with the die facing up

The inner lattice panel is VERY tiny and petite

25 (cuts just a smidge under

Packaging was not an option either and sadly mold fees made it much harder for us to make a large variety of dies in the states

Largest layer approx 4 inches

The card in the photo are those actual measurements and the die is nested just inside

These dies are similar to our scalloped frame dies except the outer cutting edge has been removed

Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting

Approx 4x4 sized

YOU NEED TO BE WILLING TO POSSIBLY RUN THIS DIE THROUGH YOUR MACHINE A FEW TIMES TO GET EVERY PIERCE HOLE TO CUT ALL THE WAY THROUGH

Largest layer is approx 4x4