Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Test method to prove the structural design of fittings1 Scope This International Standard specifies methods of test for fittings of any form, i. e. bends, branches, tapers, intended to be used in plastics piping systems for pressure and non pressure drainage and sewerage or water supply made of glass reinforced thermosetting plastics (GRP). This International Standard is applicable to fittings, in order to test their structural design, but is not applicable to connecting joint systems. It assumes that

When the BS ISO 10002 complaints-handling process is implemented

which specify a dynamic test of mechanical resistance at the conclusion of which these devices should present neither fractures

— dead mass

f) structural integrity

are a group of bacteria that resides in the intestinal tract of water

and some of the operational issues related to the distributed nature of the amplification process

optical amplifiers

Guidance is given concerning the appropriate application of electrical protection systems

Updated to national measures and frequencies designated for ISM use

ISO/TS 16976‑4 describes how much additional impediment people can tolerate and contains values that can be used to judge the acceptability of an RPD

with a recommended flow pressure range of 0

an energy storage system