Continuously hot-rolled low carbon steel sheet and strip for cold forming. Technical delivery conditionsThis European Standard specifies the grades of continuously hot rolled low carbon steel sheet and strip (in coils) for cold forming. Depending on its actual width, strip is classified as: hot rolled wide strip if its width is greater than or equal to 600 mm hot rolled slit wide strip, if its width is less than 600 mm. For each grade, it specifies the chemical composition and the mechanical properties. This European Standard is applicable to products

a part of the BS 5839 series

According to the CEN/CENELEC Internal Regulations

BS EN 61340-5-1:2007 applies to activities that: manufacture

hazardous event investigation

Condition of delivery

This standard gives general guidance for the satisfactory production and control of welding and details the possible detrimental phenomena which may occur with advice on methods by which they may be avoided

The user should refer to IEC 61340-5-2 for guidance on the implementation of this standard

Note 2: BS EN 15016-1 does not apply to building documentation

The standard does not cover individual items of electrical equipment except with regard to their selection for specific aspects of use

Content presentation

Water trough barriers are autonomous protective systems by reducing the effects of combustible dust and/or firedamp explosions in underground mines to a sufficient level of safety

The relevant specification defines: