Metallic tube connectors for fluid power and general use - Split collet compression fittings1 Scope This part of BS 4368 specifies general and dimensional requirements for the design and performance of collet compression fittings which are suitable for use with ferrous and non ferrous tubes with outside diameters from 6 mm to 50 mm inclusive. They are intended for the connection of plain end tubes and hose fittings to ports in accordance with BS EN ISO 61491, BS EN ISO 11791 and BS EN ISO 99741. The limits of pressure and temperature of use

Materials and components as well as jointing have been addressed in BS 6891

BS 6571-2 walks you through aspects such as radio interference

ISO 3740 provides guidance on the selection of one or more of these standards

and phenyl isocyanate (PhI)

• equipment in close proximity to receiving antennas

It is applicable to animal feeding stuffs with a fat content of up to 50 %

Manufacturers of paraffin waxes and petroleum products

Substantial changes to content relating to sea-state and loads

This helps in designing and constructing these quartz crystal units used in electronic devices

Guidelines for determining environmental costs and benefits

Taxi marshalling

designation HR 5C