DT764NE - TRADITIONAL DOWNPIPE SPARE SOCKET (Non Eared) - 76mm DIATraditional aluminium downpipe socket (non eared) For 76mm aluminium pipes. Spare cast aluminium sockets enable the use of pipes that have been cut down. The socket is inserted onto a plain ended pipe section and silicone sealed into position. Ideally 24hrs should be given before use to allow the silicone sealant to set. Fits over plain ended pipe section for utilising pipe offcuts.

Deepflow & Box gutters - Sealant is applied between the two joint gasket spacers supplied with each fitting

Spare internal joint piece that enables the use of 72x72mm pipes that have been cut down

Apply over fascia board joints & bond using high performance silicone

mounting directly to the top surface

Provided at a 30-degree incline

Required for 135-degree turns in gutter runs

Flow capacity: 3

providing marine-grade toughness

9 l/s at end

Use two external 90 degree angle covers for the corners

Our 128mm wide x 75mm deep x 3 metre long deepflow aluminium gutter length is produced from 6063 T6 hardened aluminium extrusion

Aluminium sheet soffit board polyester powder coated with architectural grade exterior paint to decorative faces