Railway applications. Track. Performance requirements for fastening systems - Fastening systems for wood sleepers1 Scope This European Standard is applicable to fastening systems, in categories A C and E as specified in EN 13481 1: 2012, 3. 1, for use on wood sleepers in ballasted track with maximum axle loads and minimum curve radii in accordance with Table 1. Table 1 Fastening category criteria Category Maximum design axle load Minimum curve radius kN m A 130 40 B 180 80 C 260 150 E 350 150 NOTE The maximum axle load for categories A and B does not apply to

ISO 14006 - to environmental declarations ISO 14025 - environmental labelling ISO 14024 and life cycle assessment ISO 14040

This Technical Specification describes a procedure for the qualitative detection of peanut (Arachis hypogaea) in chocolate using real-time PCR based on the gene for the peanut allergen Ara h 2 [4]

BS EN 4358 specifies the characteristics of drivers

The method is used to investigate the flexural behaviour of the test specimens and to determine the flexural strength

Design the different phases of the investigation

intended for medical diagnosis and imaging

(with their corresponding metric equivalents) and to include requirements relating to micrometers with interchangeable anvils and various measuring ranges up to 24in

Transportable machines with a maximum saw blade diameter of ≤315 mm

Why should you use BS EN 60216-5- RTE of an insulating material

For measurements made under ambient conditions

Gives guidance on the applicability and use of isothermal calorimetry for calculation of the net reaction rate of the heat producing reactions of solid biofuel pellets

The density of a body is defined as its mass divided by its volume